Send Us a Photo — We'll Identify Your Connector
Not sure which automotive connector you need? Take a photo of the plug and our team will match it against our range of over 5,000 connectors and tell you exactly what fits.
Photo guide
How to photograph your connector
We need a clear photo of the front face of the connector — the end that plugs in, where you can see the pin holes. That single view tells us more than anything else. Photos of the back or the side can’t be identified.
The FACE, straight on
This is the one we need. Point the camera square at the end that plugs in, so every pin hole and the locking tab are visible.
Not the back
The wire end looks the same on hundreds of different connectors. We can’t identify it from behind.
Not from the side
A side-on angle hides the pin layout completely. Turn the plug to face you before you shoot.
Not far away or blurry
Fill the frame in good light. If it’s small, dark or out of focus we can’t count the pins.
Step 1
Take or upload your photos
Line the face of the connector up inside the guide below — it sets the distance and angle for you. You can add up to 4 photos.
Your photos stay on this page until you send them.
Step 2
Tell us about it
A few details help us narrow it down fast.
- Photograph the front face first — the end that plugs in, with the pin holes showing
- Include any numbers moulded into the plastic housing
- Put a coin or ruler beside it if you can — it shows the scale
- Tell us if it’s the male or female half you need